Where is the cabin filter on Logan. Salon filter "Renault Logan": replacement, installation and price. Possible breakdowns and their causes

In order for the air in the cabin of your car always remained clean and enjoyable, it should be regularly replaced by a salon filter. In addition, salon filter It affects the work of the heater and air conditioner, so it is extremely recommended to neglect its replacement.

When you need to change the cabin filter

According to the regulation of the manufacturer's plant, the filter replacement should be performed every scheduled maintenance, that is, every 15,000 km of run. If you serve your car yourself, we advise you to replace more often. For example, in 8-10 thousand km of run. For this mileage, the filter is covered with dust and worse passes the air into the car's salon.

The cabin filter affects the operation of the heater and air conditioning. If he is clogged, the air through it is worse, therefore, the heater will warm worse, and the air conditioner will give a weak flow of air. If you notice that the stove, or the air conditioner began to work worse, it's time to check the cabin filter.

What to choose a filter for installation in Logan 2

If you decide to install an original filter, you can buy it according to the article RENAULT 77 01 062 227. Its cost is high enough, so when frequent replacement Filters are better to choose analogs. The cost of them is significantly lower than the original, but the quality is neither almost worse than the original.

• AMD AMDJFC86 from 320 rub
• AVANTECH CF0201 from 400 rubles
• Big Filter GB9906 from 300 rubles
• Big Filter GB9906C from 450 rubles (coal)
• Bosch 1 987 432 120 from 500 rub
• Fortech FS031 from 280 rub
• FRANCECAR FCR210131 from 250 rubles
• Lynxauto lac215 from 500 rubles
• Lynxauto LAC215C from 600 rubles

From the analogs proposed above, you can choose both ordinary paper and carbon filter. Many of the motorists believe that the coal filter is better cleaning the air arrived from the street.

Where is the cabin filter on Logan 2

Like most cars, the cabin filter at Logan 2 generation is located on the right under the glove compartment. To get to it there is no need to dismantle the glove box, it will only take to bring the hand to it and pull out the filter.

Instructions for self-replacement filter

So, in order to get to the filter, you will need to cover your hand to the glove box and grop there is the cabinet cover of the cabin filter. It can be twisted on 2 screws, so to dismantle the lid, they will have to unscrew.

Pull out the old filter, clean the housing from dust

We establish a new cabin filter pre-squeezing it with harmonica for convenience of mounting.

This is how old and new filters look like.

This replacement completed. If you have any questions, ask them in the comments below.

In order to breathe fresh air in the car, you need a clean, impedited cabin filter. If you notice that with the maximum blowing enabled, the air flow is too weak, or in the cabin it began to stink some damp or dust, it means that you have to change your cabin filter. Today we will tell you how to replace the cabin filter on Renault Logan.

What threatens the lack of filter or its worn

First, if you do not have a salon filter, a lot of dust may appear on the interior decoration. The contaminated filter is better preventing into penetration of dirty particles with a large diameter, but it is not so effective as the purification of the air with a new filter. Therefore, it is better to replace it after the expiration of the service life.

Location

You need to know that the manufacturer in this car does not provide a cabin filter, although it is very important. BUT! For him, the landing place is provided (by the way, covered by the usual plug). There is this place near front passenger In the zone of his legs on the left.

Instruction

The entire Salon System System is relatively simple. So you can replace the filter not at the station maintenance, and yourself. Only you need to choose the right item, otherwise it simply does not fit.

Codes of cleaning products suitable forReno Logan.:

• Original - code 7701062227 (coal).
• Delphi - TSP0325178C code (as coal).
• Delphi - code TSP0325178 (normal).
• AMC - NC2008 9 (Normal).

The prices of them range from five hundred to a thousand rubles, depending on the manufacturer and type (coal or ordinary).

Buying a cleaning element, make sure that there is a plastic cover. It serves to securely fix the filter. If there is no one, then you will not be able to properly install the air filtration system.

Devices and tools

In fact, you will not need too many tools. Their full list:

• Knife (scalpel, as option).
• A vacuum cleaner.
• Flashlight.
• Line.

If there is still a plug

1. Using a knife or scalpel, you need to cut the plug itself. Draw neatly, slowly, so as not to touch anything inside an important ventilation system and the filter itself. Having done this, you will open the hole in which the filter should be, but now it is not there. If you are afraid to make a hole more or less than a filter, you can measure the dimensions of the lineup, and do everything with greater accuracy.
2. Now you must clean everything from dirt, dust and possible condensate inside, which has accumulated there for all the time of operation.
3. After all the accomplished and described actions, simply install the filter on its rightful place.

The entire filter installation process can be viewed in the video material:

Replacing already existing filter

1. To replace the cleaning item, first need to be pulled out from the landing site. Pull the plastic handle at the bottom of the filter cover and remove it. When you inspect it and see that it has too many whole garbage, dust and other unwanted things in the cabin, you will understand that it will be necessary to replace the old filter to the new one.
2. Now you need to clean the place in which the filter was from dust and garbage, which accumulated there during the operation of the ventilation system, and which can negatively affect the operation of the new filter. For convenience, you can use the vacuum cleaner, or, if you are not afraid to get into the hands of the old rag, which you will not feel sorry, and it is completely wiped everything inside.
3. Since there is already an order inside, you can start installing a new cabin filter. If you want to use the old filter, I prehast up, cleaning or moving it, then we are extremely not recommended to do this. At first glance, he may seem clean to you, but there will still be a lot of harmful plates and dirt, which will not be very pleasant to breathe. When installing a new filter in its socket, it is necessary to squeeze the front part on both sides so that it breaks inside without any problems. First attach the upper part, and then the bottom right to click. If the click has occurred, it means that the filter is installed securely and will not fall.
4. After all these actions, you should be convinced of the correctness and tightness of the entire system. To find out whether everything works correctly, you need to include blowing on the maximum and check the design slots. If anywhere does not go out, then you are all done correctly.

All this work can take a maximum of thirty minutes.

Congratulations! You just made a successful installation of the cabin filter to your Reno Logan. Having done everything with your own hands, with the help of this guide, you saved your money, time, and most importantly - prevented possible diseases associated with frequent inhalation of various malicious fungi, which accumulate in the filter.

Differences in the installation of the cabin filter on Reno Logan 2

In principle, in the second-generation car, everything is arranged in the same way as in the first generation machine: the recess under the filter is located in the same place. The only difference can be considered the shape of the plug in the machines different generations. The procedures for extracting the old filter, the preparation of the place and the installation of the new filter are not fundamentally different. If you do not have a salon air purifier in the car, then you have to install it extremely. After all, spend thirty minutes to make ride more comfortable, reduce the risk of infection with all sorts of fungi, prevent the accumulation of dust in the cabin, is not so difficult.

Coal filters cope significantly better with the task, rather than ordinary.

Good day! In this article you will find information about. Let's start with the fact that the replacement procedure is very simple and requires minimal effort. However, you should know that not all Reno Logan cars from the plant are equipped with a salon filter. This means not only that in the ventilation system there is no filter element, but there is no hole for its installation. By the way, this procedure is best done together with, since you simultaneously spend a complete car.

Such a situation is common in Lada Largus, where a similar system of heating and ventilation of the cabin is installed. In one of our articles, we have already told. So the mercy is pleased to whom it is interesting. And we will return to our topic.

The cabin filter Renault Logan is located in the niche for the front passenger's legs under the glove compartment. If you have looked there and saw the filtering element plug, you can assume that it is lucky and some additional efforts will not need. It will only be left to pull out the old cabin filter and install a new one in its place. If only weave plastic on the site of the usual plug, then you are less fortunate. You will have to cut the hole before installing the cabin filter. Suppose there are no holes for the interior filter. Where to begin?

Installation of the cabin filter Renault Logan (Renault Logan)

We are patient, take the construction knife and we are comfortable. The photo below shows how you will have to settle. P.S.: Photos from the site Drive2.ru, from user with nickname 012.

Gently cut the hole with a knife, as shown in the figure below.

Do not forget to leave about 5 mm from above. This part is needed for a cabin filter retainer. Be extremely careful when working with a knife. First, you can cut down. Secondly, you can damage the elements of the heater.

When the hole is cut, processed the edges of the sandpaper, so that everything is neat. After completing this stage, it is necessary to remove the entire garbage from the stove and rub a damp cloth.

And only after that move directly to replace the main filter Renault Logan 1.4 or 1.6. Now you need to install the cabin filter in place. Slightly squeeze the filter, thereby deforming the filter element. Then we completely start the upper part and then we pound the bottom.

If you are all done correctly, the filter will easily be in place. The next step is to check the system. Turn on the oven for maximum speed and substitute your hand to the filter. If you don't think anything, then you did everything right and on this work on replace the main filter Renault Loganofficially finished.

Please note that the filter must be taken at once with a plastic tray. Those. Such filters are sold along with the plug. We recommend purchasing a TSN filter. These filters have proven themselves at the ratio of "quality price". Article for search 9.7.476. If you are a supporter original details, use to search for article 27 27 728 35r.

Replacing salon filter Renault Logan

On the installation of the cabin filter on Renault Logan, we already told in detail in the previous paragraph. The replacement procedure is distinguished by only the fact that you will not need to cut a hole for the interior filter. It will only be necessary to dismantle the old filter and install a new one in its place, pre-cleaved the installation location from the accumulated dirt.

For the convenience of installing and replacing the salon filter on Renault Logan 1.4 and 1.6, I will also leave a schematic instruction that you can use it.

Replacing the cabin filter Renault Logan video

And the bonus to this article will be video Replacement Salon Filter on Renault Loganwhich you can look in the player below. Pleasant viewing, and we will finish our article on this. Thank you for your attention to new meetings! You can leave all your questions in the comments to the article!

It is an integral part of the heating system. It is he who stands at the entrance and separates all the dirt and dust from the air penetrating the street. And if B. winter (When the earth is covered with a large layer of snow) it is not particularly important, then in the summer heat (especially when moving on soil roads) Riding without it becomes unbearable. But Logan manufacturers considered it not a very important part, and decided not to install on some copies. Instead, a cast plug is installed instead. A very strange solution, it was possible that it was possible to install a removable plug, and then the installation process would take significantly lower time.

Where is

To find out if you have a similar option or not, you need to carefully look at the right side of the stove. Where the passenger usually puts his left foot (the very close part of the heater hull to the engine), the cast glitch of black color will be located. Behind the plug and the locked channel for installing the item. Check if it is installed or not, you need when buying a car. Otherwise, due to long-term operation, air circulation in the stove radiator due to sticking the dirt and dust on its cells can be impaired. This negatively affects the operation of the heating system, and the heater begins to warm worse, and with prolonged action it may remove the radiator.

How to install

The installation of the cabin filter can be made both independently and at car maintenance stations. This procedure is simple, but requiring accuracy.

How to replace

If you were lucky enough to become the owner of a Logan instance with the already installed filtering element, then it will not be changed. And if there is a new one, a few minutes will take.

Replacing the cabin filter Renault Logan, not difficult, but very important operation. It will provide the influx of purified air into the salon. For the product, it was not necessary to remove the entire heater, and it is enough to bring to the torpedo. All this can be done by itself without referring to the maintenance station.

.
Year of issue: 2015.
Asks: Giant Sergey.
Essence of the question: Something I do not understand where the cabin filter is located on Renault Logan?

Guys, hello everyone. Something I do not understand where the cabin filter is located on Renault Logan? The seller in the auto shop said that not all Logan had a filter, on the first versions it was not exactly. He is sure of that, since he himself owned Logan. But I have a fresh model, it is already at the level of Solaris and Rio, really not really.

In the same store, the seller said that I am a stack of a stationery knife, as you have to cut a regular plastic. Is it really that?

The cabin filter is absent from the factory on most of the packages

Our auto expert is responsible for this question. That's what he says.

The Following Two Tabs Change Content Below.

I own Renault Megan 2 car, before that there were Citroen and Peugeot. I work in the service area dealer Center, so I know the device of the car "from and to". You can always contact me for advice.

You will be surprised, but 90% of Logan from the plant are not equipped with a salon filter.

Do not forget that the car was initially a super-economy, it was from there "the legs grow" from this phenomenon. For example, a separate "ashtray and" in the configurator will cost 1,990 rubles (at the time of writing the article). Therefore, many owners are purchased by these options separately, and this also applies to the salon filter.

The cabin filter is on the right under the feet of passengers

The cabin filter is to the right of the central console - under the legs at the front passenger. Most likely you will see it there.

Under this plug is a vent hole

Installing the cabin filter

The procedure is generally not complicated, but requires certain skills and skills. To do this, you need a sharp knife. Some use a stationery knife, with proper experience and skill them will be easier. But we recommend using an ordinary knife, as the stationery can be "injured".

New cabin filter on its "legitimate" place

Article of the cabin filter

The original article of the cabin filter on Renault Logan - 82 01 370 532.

Analog Filter K 1152

Salon filter Delphi TSP0325178C - costs more expensive, but according to reviews it is better