Replacing the spark plugs on the polo sedan 1.6. How to replace ignition candles on Volkswagen Polo Sedan. Article and cost of original candles on Volkswagen Polo and their analogues

Replacing the spark plugs on the Volkswagen Polo sedan 1.6 is an inline operation that is required at the time of the second scheduled. However, due to the poor quality of a combustible mixture, an incorrectly adjusted ignition, or by virtue of other candle factors, a previously specified period can be exhausted and they will need to be changed without waiting for the nearest those. inspection. Well, how to do it yourself, we will tell in the article below.

List of necessary tools

In order to replace the ignition candles on the Volkswagen Polo Sedan, the driver has passed as quickly and successfully, the driver should prepare all the necessary tools for the procedure. It includes:

• Special hook for pulling the plugs (can be found included in the basic tools of polo sedan);
• A screwdriver with a solid nozzle (in case you will not manage the knob of the key, it will not be quite convenient);
• The most common candlestone (on the polo sedans 2016 and 2017, the key is applied to 16).

Well, do not forget about the new set of candles. Since without them all of the above toolkit will not need.

Step-by-step instruction

Before starting to change the candles on the Volkswagen Polo sedan 1.6, before them should be reached. To do this, you will need to sweep the two mounts on the plastic cover of the cylinder block and remove it aside, so that it does not interfere in the future.

Next, to get to the candle, you will need to remove the coil with contacts. And this is simple enough, with the help of a special hook, or, at worst, with the help of a conventional nail bent at an angle of 90 degrees.

Lower the hook into the hole with the coil, spend it into a special hole (at the edges of each coil on polo sedans sedan 2017 and 2016 there are special plastic ears, with which the device can be pulled out from the groove), and pull the hook.

However, it should be remembered that a pad with wires with wires are mounted on top to the coil, which will need to be disconnected by pressing the retainer. Therefore, pulling the coil is not recommended too quickly, in order not to spoil the integrity of the wires.

So we opened access to one of the four candles. Now it remains only to throw a pre-prepared key on it and unscrew it from the socket (earlier, considering how to replace the ignition candles on the Volkswagen Polo sedan 1.6 We mentioned that the key should be marked 16. And this is a very important aspect. After all, if you choose another key size The candle will not tightly hold on it when disassembled, which will cause serious difficulties with its extraction from the motor).

The above procedure should be repeated for the three remaining candles. Well, after all four consumables are in your hands, you can proceed to replace them with new elements. This, as a rule, also does not arise difficulties. After all, if you know how to remove candles, the scheme of their installation is also known to you, as it repeats the above procedure, only in the reverse order. And for better perception of the picture, we recommend that you view a brief video instruction attached below.

Increased gasoline consumption, slow acceleration, bad launch of the car, periodically troit the engine? The first thing with such symptoms shows the replacement of the VOLKSWAGEN POLO candles. It is usually produced by the regulation of the VAG concern, tied to run, but you should get to the "good" refueling and writing. It is the opinion that the durability of the ignition candles is very dependent on their design, they say, the installation of iridium instead of the usual elongates the replacement interval by 2-3 times. Practice shows that it is not necessary to invent the wheel: better factory candles in 95% of cases nothing works better.

Given:

• Car: Volkswagen Polo
• Year of release: 2011
• Model year: 2012
• Engine: CFNA (1.6 liters, 1598 cu. See, 105 hp)
• Features of the DVS: Distributed injection and system of stepless change phases of gas distribution valves
• Transmission: MFZ
• Preselective PPP Robot DSG: No
• Mileage: 41,000 kilometers

Requires:

• Replace spark plugs

Winter is close, you need to be particularly vigilant, the mileage is already under 50 thousand kilometers, and the VOLKSWAGEN Polo candle replacement is only dreaming. We put on the covers, produce compulsory primary instrumental and computer diagnostics, after which we drive the car to the masters.

Drop the engine protective cover to provide access to ignition coils.

If you look at, one of the coils is partially pulled out. Many services enjoy scolding for this, but we have for all occasions of life there is a special tool that allows you to fulfill the task, and do not damage anything.

And our candles were already thinking about: beaten, eaten, in Nagar and with a big gap.

We take the packaging of new NGK candles (OEM 101905601F, NGK 5960), we neatly install it in the seats and twist only with a torque wrench.

"Stop, where does NGK come from if you put Bosch from the factory?", You can easily exclaim you. The essence is that in different years, the conveyor was supplied both Bosch and NGK. You can buy "original" Volkswagen Polo candles, but inside will lie one of the specified manufacturers. Why pay more?

We put on the place of the ignition coil (OEM 036905715G), we put the protective engine of the engine and next to the "Replacing the VOLKSWAGEN Polo Candle Replacement" put the cross. Machine is ready, you can give out.

Good day. Today we have a Volkswagen Polo Sedan car service with a 1.6 engine. He came to us with problems in the engine. On the cold engine sometimes strained. Therefore, it was decided to change the spark plugs. In this article, we will tell you how to remove and replace the ignition candles in the engine 1.6 on VW Polo Sedan.

Vendor code: Ignition Candle - 0 242 236 565

Instruments: To replace the candles on the Volkswagen Polo Sedan, you need a flat screwdriver and a candle wrench on 16 "

Removing and replacing the ignition candles on Volkswagen Polo Sedan 1.6:

Candles are preferably on the cool engine, as the candles are very hot. To get to the spark plugs, you need to remove the top plug while driving the latch.

Then you will see 4 ignition coils. On parties there are wiring clamps. You can open them so as not to remove the terminal from the ignition coils.

Then pull up the ignition coil.

Unscrew the old spark plug and change to a new one.

The state of the old and new spark plug.

The entire process for removing and replacing the spark plugs on Volkswagen Polo Sedan 1.6, took about 20 minutes. After that, the engine began to work as a new one. No failures and trims. It is advisable to change the candles at least 30-40 thousand kilometers. Good luck on the roads!

According to the regulation of the maintenance of the car Volkswagen Polo, the spark plug in the engine must be changed every 30 thousand km. Run. Technical inspection of candles must be produced every 15 thousand km. Run. If there are cracks on the housing or depletion of the insulator during visual inspection, the candles must be replaced. The service life depends on various indirect parameters - high engine operation temperatures, fuel and oil quality, use of various additives. The wear of the candles, the less specified mileage, is associated with the extremely low quality of the combustible mixture or the incorrectly configured point of ignition.
Basic signs indicating a malfunction of the ignition candles: difficulties when starting the engine, the operation of the motor at idle is unstable, the engine "Troit" during acceleration increases the fuel consumption, the engine power, "failures" are reduced when the gas pedal is pressed.
The replacement of ignition candles will be able to perform any engineer with initial preparation, this procedure does not require special knowledge and experience of repair work. All work must be carried out on a cold engine. The surface of all parts must be cleaned to prevent garbage from entering the engine combustion chambers.
From the tool you need a candle wrench to 16 and a flat screwdriver. To provide access to the candlestones, you need to remove the plastic cover, disconnect the wiring and remove the ignition coils with the use of a special puller. You can remove the coils with a simple screwdriver, but at the same time act is needed extremely gently, which is not damaging the ignition coils and plastic fasteners.
The main work of the candles in the engine ignition system is to maintain a sufficient spark charge required for a normal engine. The long-term use of worn candles can cause the failure of the exhaust gas converter and increase the gasoline emission coefficient and toxic substances into the atmosphere.

Attention! This video is not official Instructions and guidance on the repair of the car.

• VW Polo Sedan Ignition Candle Replacement

Volkswagen Polo Sedan Thu-2 Ignition Candle Replacement.

Detailed description How to replace ignition candles on Volkswagen Polo Sedan.
According to the service book, they are replaced every 30000km.
Installed candles of the company VAG Candle code: 101905601F.

Other Maintenance Videos Volkswagen Polo Sedan:
Reset the counter: http://youtu.be/-8mhwj81lj8
Replacing the engine oil: http://youtu.be/bcqn7gukes8
Replacing the oil filter: http://youtu.be/o2hbc7pomti
Replacing the fuel filter: http://youtu.be/xkcboygzrgu
Replacing the cabin filter: http://youtu.be/htgpu8lroos
Replacing the air filter: http://youtu.be/gpdpmjetvbg.

Visit my second channel YouTube: http://www.youtube.com/user/usetip?sub_confirmation\u003d1

We proceed to replacing candles, according to the regulations, this procedure should be carried out every 60 thousand kilometers of the mileage. First of all, remove plastic decorative protection.

Removed the lid, got to the coils.

We take a screwdriver, take turns soaring the coils and raise them so that they come out of the candles from the candlestones.

The last candle is simply so possible to get it, you need to disconnect the power connector.

We take the sixteenth head of the candle, put it on the key.

Now alternately unscrew the candles.

Take out an old candle from the key, we insert the new and twist.

Having finished with candles, we collect everything back, in particular, set the coils on their places.

We put the engine cover in place. All candles are changed.

On the polo sedan is a gasoline engine 1.6 liters with a capacity of 105 hp To properly function all systems, it is necessary to follow the technical condition of your car. As part of preparation for periodic, the replacement of candles on the Volkswagen Polo sedan is shown.

When you need to change the candles on the polo sedan

According to the instructions for maintenance of this car, the replacement of the candles is carried out after every 60,000 km.

Installation of platinum or iridium spraying candles allow you to extend this service life. Also, on time, the replacement must be required to check the components of the ignition system parts, such as: ignition coils, candle tips and coil fuses.

Checking the candles requires a visual inspection for the presence of soot (a lot can tell the color of Nagara), oil spots and of course, the same gap.

After removing the ignition coils, in order to avoid dust and dirt in the cylinder block, it is necessary to blow with air compressed candle wells.

When checking the candles, if the gap between the electrodes is less or more than 1.0-1.1, then it is necessary to adjust it to the specified values, fading the electrode.

It is recommended, when installing new candles, apply a lubricatory paste g 052141 A2 on the ignition coil. The use of this paste prevents both the candles to the tip of the ignition coil and its threaded part.

Required tools and materials for replacement of candles

Full list What is necessary for work:

• shredded flat;
• special sleep for 16 mm candles;
• dynamometer key;
• candle stripping brush;
• set of spark plugs.

Catalog materials for replacement materials:

Original spark plugs for Volkswagen Polo Sedan: Longlife spark plug from NGK VAG101905617C ART. 101905617C and Bosch VAG101905601F ART. 101905601F at a price of 375 rubles for 1pc.

Their analogue of the production company "DENSO" Ignition Candle "Nickel" Art. KJ20DRM11 - Cost 190 rubles / pcs.; From the company NGK - 5960 worth 200 rubles per piece.

Paste lubricant VAG art. G052141A2 - price 1600 p. For a 20 gram tube, which is enough for you for a long time.

The price of spare parts is relevant for the summer of 2017 for Moscow and the region.

Watch an interesting video on this topic.