How to change oil into automatic transmission on Opel Corsa? How to replace oil in an automatic transmission box Opel Corsa automatic transmission oil for Opel Corsa 1.4

the main / Engine

If you need a replacement of oil into the Opel Corsa automatic transmission, it is not necessary to contact the service at all. This procedure can be done at home, having a minimum set of tools at hand. And now let's wonder how to do it right.

[Hide]

Step-by-step instruction

Instruments

Before starting the procedure, you need to make sure that there is everything at hand required tools. To successfully replace oil in the Opel Corsa automatic transmission, you will need such equipment:

a drainage container in which the volume can be measured;
gate with a replaceable end head;
ribbon key;
latex gloves.

Stages

Collecting everything you need, you can start execution. To replace the following instructions, follow the following instructions:

Previously, to warm up automatic transmission, it is necessary to drive on your "Opel Corsa" about 5 km.
Exactly put the car on the pit and unscrew the gearbox pallet cover.
Wait until the maximum amount of fluid is somewhat. It must be merged into the container so that you can estimate the volume.
Carefully unscrew the pallet. It will still have some amount of oil that can pour. Drain it in the same container.
Remove the filter from the automatic transmission (at the same time leaving some more fluid).
Clean the filter and the pallet from the plaque and insert back. The filter is best to clean with gasoline.
Through the hole for the probe, you need to pour new transmission oil. The volume of the flooded fluid should correspond to the volume already poured.
Disconnect the cooling tube from the oil radiator and connect the hoses from their place. The free end of the hoses lower the prepared container in advance.
Next, you need to start the motor and wait a few seconds until the old liquid is absorbed from the tubes. As soon as the fresh oil starts to flow, you can join the engine. Thus, the outstanding of the old oil is new. It is better to do this step with a partner to drown out the engine before the automatic transmission is found too much liquid.
Remove the hoses and attach back the tube.

On this, the replacement of transmission oil in Opel Corsa will be completed. It will only remain to measure its level in the cold (immediately after fill) and hot (after several kilometers of the mileage) condition.

Car Opel Corsa in the parking lot

If you buy a new Opel Corsa, the first replacement of transmission oil will be required not soon. Usually starting refueling is enough for 2-3 years or about 100 thousand mileage kilometers. But over time, these procedures should be participated. After each recalculation, the oil portion remains among the mechanisms of the box, and an incomplete replacement occurs, but only a partial dilution old liquid New.

Only original ATF oils costs. This will help keep the good job of the PPC and will save you from non-warrant breaks. It is necessary to accurately comply with the "hot" and "cold" level, which are indicated on the dipstick. For the car will be harmful both shortage and excess fluid.

Video "On the replacement of oil in an automatic transmission"

This video describes in detail the replacement procedure. transmission fluid in car automatic transmission.

Have you performed a replacement of liquid into automatic transmission? Share your opinion and experience with our readers!

The problem always comes suddenly. Ubiquitable case: the owner of the car, who drove on it not one year, breaking all the norms of exploitation and closing his eyes to the characteristic signs, is surprised so that way the past breakdown! Meanwhile, car service An occupation is not so costly and heavy. The minimum knowledge of the principles of the machine work, a little time and not the most curves hands will help to avoid most of the problems that may arise in the way. And the devil is usually hiding in the trifles.

The process of replacing the oil

Transmission fluid in the car should be changed approximately every 20 - 100 thousand km. Male, depending on the operating conditions. This frequency ensures the stability of the gearbox and significantly increases its service life.

The procedure for replacing the oil into the automatic transmission on the Opel Corsa is universal for all models of these machines. The design of the gearbox from the model to the model practically did not change, so regardless of which the letter is after the word of the Corsa in the name of the car model - B, V or D - procedure replacement ATF. It will look about the same.

Before starting the operation, you must put the car on watching pit or overpass and switch the transfer to R. mode

The oil is replaced with a heated engine to increase its turnover. The temperature of the oil should be no less than 60 ° C, so in obligatory It is necessary to comply with safety and work in protective clothing to avoid injury and burns!

Tools and spare parts that will be needed when replacing ATF in the gearbox:

rubber gloves (remember about safety technician!);
set of wrenches;
ribbon key;
packaging for collecting waste liquid;
new oil filter, pallet lining, sealant rings.
of course, fresh ATF.

The fluids will need about three liters for partial replacement and in the area of \u200b\u200bfive - for full. In good full replacement Oils in Opel Corsa should be carried out in the car service, since completely from the old oil in the automatic transmission can only be eliminated by its complete dismantling. However, in the conditions of the garage, it is possible to achieve a similar effect.

Partial oil change in automatic transmission

ATF partial replacement is different from the full that the new transmission fluid is mixed with a certain number of old. This procedure is much easier and cheaper, while significantly extends the service life of the gearbox.

First of all, it is necessary to carry out the drain of the old oil with the Opel Corsa automatic transmission. To do this, we find the pallet of the gearbox crankcase (the shield is previously removed motor compartment). Drain of the old liquid is carried out through the drain hole in the pallet. Under the hole is the container prepared for collecting spent ATP, unscrewed drain plug (Use gloves! Great probability of burns!), after which the oil itself begins to flow into the container. There should be about 3 liters.
The pallet mounting bolts are unscrewed, the pallet is removed. It still remains oil, so the operation should be carried out carefully.
Next, it is necessary to clean the pallet from the old oil, products of working out and lining residues. This is done with a rag moistened in a solvent or gasoline. The lining is changing to a new one.
Removing the pallet opened access to the oil filter. It must also be cleaned or - what will be better - replace.
Filter and pallet are installed on the spot. The drain hole is blocked by a new tube with replaced sealing rings.
Fresh oil poured on the side of the hood through the hole for the probe. The amount of flooded fluid must correspond to the number of lowered (about 3 liters).
The bay hole is tightly closed with a plug with replaceable seals.
Then it is worth starting the car engine and, when the brake is crucified, alternately switch the transmissions from P to d, lingering on each 5-10 seconds.
Check the oil level with the motor turned on. If necessary, fill the right amount.

Full oil change in automatic transmission

The second method is more productive, but also somewhat more complex. With it happens more full shift Butter, though, again, not quite, because we will not dismantle the automatic transmission completely. It consists in the fact that there will be more than two liters of transmission fluid, located in the oil transmission oil. This will maximize the replacement of fluid in the box and increase its service life.

We repeat steps 1-7 from the operation by partial replacement Oils in Opel Corsa automatic transmission.
After that, the oil pipes from the cooling radiator should be disconnected. The hoses are connected to the scene of the tubes, the free ends of which are lowered into the exhaust capacity and are fixed on both ends in order to avoid leakage.
Motor car starts. Old oil will begin to flow on the hoses in the container. You need to be very attentive and pay attention when, instead of the old oil, a new one will start. At this point, it is necessary to drown out the engine, wait until the oil stops flowing, then connect the tap tube back. You should immediately replace rubber seals in them.
Check the oil level and fill the required amount.

What happens to the machine if insufficient oil in the automatic transmission?

Transmission fluid performs several important functions in the car:

wars heat from the working parts of the gearbox;
performs the role of lubrication and friction fluid;
prevents corrosion;
shears the wear products of the gear, leaving them on the oil filter.

Thus, the disadvantage or excessive pollution of oil in the automatic transmission leads to the wear of parts and overheating the gearbox. In the most difficult cases, it may be necessary to replace individual details or the entire box that flies in a penny.

On malfunction automatic transmission can indicate the following signs:

problem with the transmission of the car: Switching jerks, delays and passing gears when switching;
slug car;
outsided sounds in the box: grinding, knock, hum, etc.
traces of leakage of transmission fluid.

Also, the problems of the oil can also prompt about problems:

loss of its transparency, strong blackening;
heterogeneity of the mass, the presence of metal chips;
core smell.

When one or more of these signs are detected, it is worth contacting a specialist for diagnosis and repair required. Therefore, in order to avoid breakdowns of the gearbox, the replacement of oil in the automatic transmission in Opel Corsa should be carried out in a timely manner.

Replacing the oil in the transmission Opel Corsa - a very useful procedure, requested when independent service car. At first glance, it may seem that with the replacement of oil is able to cope only experienced motorist. Maybe however, in the case of compact hatchbeck Opel. Corsa This procedure does not take much time. This model It has a well-studied design, which allows independently at home to perform some procedures. On the example of Opel Corsa with automatic transmission, we will look at how to correctly change the oil in the box.

Replacement regulations

The frequency of oil replacement in the automatic transmission depends not only on the instructions of the manufacturer, but also from the set of other factors - for example, driving style or weather conditions. And yet, first of all, it is necessary to pay attention to what is written in the instructions, even if these numbers are inaccurate. So, the officially established regulation allows you to change the oil into the Opel Corsa automatic transmission after 100 thousand kilometers or in three years. Need to immediately say that for russian conditions Such a regulation is not suitable. In our case, the periodicity of the replacement is advisable already in 25-30 thousand kilometers.

What to fill

Of course, for automatic gearbox this level is desirable to use only original transmission oilswho will serve much longer. With this product will be confidence that the gearbox will not be out of order. Not only brand is important, but also oil parameters. They are listed in the instructions. We are talking about the levels of admission and viscosity by which you need to select suitable lubricant. And the choice of brand is a secondary matter. And yet, for the car of this level it is worth picking up something more famous.

We proceed to replacing the oil

What will you need

Technical packaging for draining waste fluid
A set of tools, including a ribbon key
Rubber gloves, towel
New transmission oil
New oil filter (if necessary)
Funnel, Hose

Sequence of work

Warming the gearbox to operating temperature - About 80 degrees. For this, a short trip around the city
Install the machine on the lift. Alternatively, you can use a viewing pit, an overpass or jack with supports
Make sure that the car is installed as soon as possible, without inclination
We provide access to the bottom of the PPC
We climb into the pit, and inspect the gearbox from the bottom. Most likely, you will have to remove the protection of the engine compartment, and thereby get access to the oil drip neck
We unscrew the cork of the neck, and we observe the process of flowing the liquid into a predetermined technical packaging
After waiting for the full oil drain, we close the hole, and measure the volume of the fusion of the old oil. It is so much fresh fluid that will be needed to enter into the filling hole.
We unscrew the bolts that hold the tray pallet. It is important to take into account that in the pallet there may be some more oil, together with mud and metal chips. Therefore, we remove the pallet neatly, without sharp movements. After disassembling the pallet, we rinse and clean it from dirt and oil residues
Next Stage - Removal oil filter. Access to it was able to ensure after dismantling the pallet. Most likely the filter will have to replace
After installing a new filter, put the pallet of the transmission box, and go to the next stage
Filling fresh oil - is performed through a hole of the measuring probe located in the subcontrol space. Once again, we will pay attention that it is necessary to pour so much oil as the old liquid was fused. For convenience, you can use the hose with funnel
We close the plug of the fuel hole, start the engine and leave it on to 5-10 minutes. At this point, you need to work in a box in several modes - to do it alternately, with a delay of 2-3 seconds on each transmission. It will provide an effective oil run across the transmission system.
Drown out motor, make control measurement
If the fluid level is normal, then the replacement process is completed, and you can begin to further operate the vehicle.